Centrifugal Separator -Automatic Models

Model Number

SF-000A

Features

Operation to the removal of the sludge is an automatic process. Manual operation is not required.
Extra management is not required, so it is really easy to use.

Structures

Processing cycle

1. Process Liquid continiously flows up through the Feed Tube.
   
2. The Impeller accelerated and distributes the Liquid into the Spinning Bowl.
   
3. Liquid flows up The Pool Surface of the Bowl as the solids separate and compact at the Perimeter of the Bowl.
   
4. The clarified Liquid passes around the Efficiency Ring and discharges through the Bowl Hub discharge ports and into the Frame Collection Chamber
   
5. The clarified liquid flows down the Drain Tubes and into the lower frame drain pan where it exists discharge fitting at the rear of the Centrifugal Separator.

Automatic cleaning cycle

1. Once the bowl fills capacity with waste solids,The Automatic cleaning Cycle is activated to remove the Solids. This Cycle is controlled by an adjustable Process Timer.
   
2. When the cleaning cycle is activated, The Separator shuts off The Feed and brakes to a complete Stop.
   
3. After the Free Liquid drains, The Sludge chute cover is pneumatically opened.
   
4. A second Pneumatic Cylinder engages the plow mechanism’s clutch socket into the plow shaft. The sprocket then turns, counter rotating plow blades altermately, clockwise and counter clockwise.
   
5. The Plowing Action discharges the compacted solids from the tapered Section of the Separator Bowl. The sludge drops through a chute into a waste receptacle below The Machine.
   
6. Upon completion of the cleaning cycle, the sludge chute cover closes,the pneumatic cylinder retracts,The Process Timer resets,and the machine resumes its process cycle. A normal cleaning cycle takes less than 5 minutes.
   

Specification